-
Hi
I am using the flow player with vimeo mpeg-dash.
When I press the start button, video plays with high quality. However, after a few seconds, it fall back to low quality.
If I change the section, it changes to high quality in a few seconds.
If I change the section to the front of the video again, it will be played in high quality.
I should always change the segment to see the front part of the video in high quality.
All the videos on my site have the same problem.
I use lightbox with high resolution and problem get partially resolved but its a little bad use lightbox in everyvideo.
-
-
Hello Francisco,
Could you please create a test page with a Vimeo video in FV Player Pro, so we could test it?
Thanks,
Eduard
Hello Francisco,
actually this looks like to be depending more on your country and connection speed than your site.
Could you please check your connection speed here? http://www.speedtest.net/
We will test if the MPEG-DASH quality is properly remembered – you should only have to switch it to say Full HD (1080p) once and then it should load that even if you are on slow network – I think it might keep loading the first segment of the video on a lower quality though.
Thanks,
Martin
Hi sorry for delay i post a example here
nothing /?
Hello Francisco,
we will improve the MPEG-DASH engine to stick to the quality which you have selected. So once you have selected 1080p by clicking it you will get that all the time.
If you have a problem that your video quality gets lower during playback, then it must be caused by some network issue – please see the questions I had about your location and internet connection speed. The MPEG-DASH engine is trying to act for your benefit – to provide smooth streaming with no drop outs.
Thanks,
Martin
Hi Martin ,
I tested a lot of times my connection and its normal you can see here
http://www.speedtest.net/result/6980432390.png
Hello Francisco,
it could be that the Vimeo CDNs are not most effective in your country. I’ll check what is the situation in Brazil like.
Thanks,
Martin
